APPLICATION:
Apply STONEWALL STONE-BOND to the substrate where EPS Foam architectural shapes are to be installed. This application is best accomplished by using a rubber float. The recommended thickness for this bonding coat is 1/4 inch. Apply a thin coat (1/8 inch) of STONEWALL STONE-BOND to the wall side of the shape and press firmly to the wall. Care should be taken to not allow either coat to skin over before application is accomplished. Mechanical fasteners(washer head nails or screws) may be needed to hold the shape in place while the STONEWALL STONE-BOND is setting.

STONEWALL ULTA-BOND may be used as a plaster base coat for EPS Foam sheathing and architectural shapes. STONEWALL STONE-BOND can be applied by hand using a brush or trowel or by spraying with an air hopper, rotor stater or piston pump. Application should be 1/8 inch in thickness. Apply STONEWALL STONE-BOND to the desired substrate with sufficient thickness to completely embed reinforcing mesh. Trowel to a flat smooth surface. Apply the finish coat A trowel to a flat smooth finish. Allow the finish coat to cure for 24 hours prior to any decorative finish coat application.

NOTE: When applying exterior stucco over STONEWALL ULTRA- BOND, 16 oz. of acrilic bonder must be added to each sack of stucco to ensure bond of the finish stucco to the STONE-BOND Basecoat.

STONE-BOND is also available in different aggregate textures. When a stronger finish over foam shapes, fiberglass reinforced STONE-BOND is available.